Page 28
Tad Pole Hot Tub Owner’s Manual
PROBLEM:
Jets are weaker than normal or do
not work at all, but in both cases the pump is
running.
Cause: 1.
Jet handle(s) is partially or fully closed.
Solution:
Open jet handle(s).
Cause: 2.
Hot tub filter cartridge is dirty.
Solution:
See "Cleaning Your Filter" in this Owner's
Manual.
Cause: 3.
There is air trapped in the hot tub
equipment or its face piping.
Solution:
Open the air-bleed valve on each pump
housing and allow air to bleed out of system. Be
sure to tighten each air-bleed valve as soon as water
starts to flow out.
Cause: 4.
The Suction Fitting(s) are blocked.
Solution:
Remove any item or debris that is blocking
each Suction Fitting.
Cause: 5.
The JetZone Divider is not installed (This
only applies to spas that have two pumps).
Solution:
Re-install in the appropriate JetPak
position. (Warning: Running your hot tub without a
JetZone Divider can cause serious damage to your
pump.)