Tadiran Telecom SUV2-H18/1CFA-N, Service Manual

Page: 24 / 67

20
Installation Manual Installation Manual
● Installation of the Outdoor Unit
1. During the transportation of the outdoor unit, two lifting ropes long enough must be used in four directions and the
separation included angle must be less than 40° prevent the center of unit deviating.
2. During the installation, M10 screws should be used to
fi x the support leg and base frame of the unit.
3. The unit should be installed on a concrete base frame with a height of 10cm.
4. The installation space of the unit should be as required in Fig.1.
Fig.1
＞
500
＞
500
＞ 500
＞
500
＞
2000
＞
2000
＞ 1000
Connection between Indoor and Outdoor Units
● Energy level and Capacity Code of the Indoor and Outdoor Units
Energy Level Capacity Code
Indoor Unit
07 23
09 26
12 35
18 52
24 71
Outdoor Unit
18 52
24 71
28 82
36 100
42 120
Table 4
Installation Space Requirements of the Outdoor Unit:
Units: mm
1. The outdoor unit with energy level 18 can drive up to two sets of indoor units, the outdoor unit 24 can drive up to three,
the outdoor unit 28/36 can drive up to four, while the outdoor unit 42 can drive up to
fi ve.
2. The sum of the capacity codes of the indoor units should be among 50%-150% of that of the outdoor unit.
● Wiring of the Power Cord
A breaker must be installed, capable of cutting off the power supply for the whole system.
1. Remove the handle(front board) of the outdoor.
2. Remove the wire clip; connect the power connection wire and signal control wire (only for cooling and heating unit) to
the wiring terminal according to the color,
fi x them with screws.
3. Fix the power connection wire and signal control wire with wire clip (only for cooling and heating unit).
4. Reinstall the handle(front board).
CAUTION!