background image

3

3.  Rotate the plastic arm vertically, then slide the arm off of its mounting pin 

and set aside.

Elevator Arm and Spring Installation

The plastic arm and spring must be installed onto the opposite gimbal (which 
doesn’t have the metal throttle ratchet arm).

1.  Slide the arm onto the arm mounting post, then rotate the arm downward 

over the gimbal.

2.  Using hemostats or needle-nose pliers, grasp one loop end of the spring 

and hook the opposite loop end of the spring onto the spring tension lever 
down inside the gimbal.

3.  Pull the spring upward and hook the top loop end onto the elevator arm, 

and release.

4.  Adjust the spring tension screw until the desired tension exists for the 

vertical movement of this stick.

Case Assembly

1. Carefully tuck all cables back inside as when the case was opened. 

2.  Align the case rear back onto the case front, 

making sure that no wires are pinched between the case parts.

 Press 

the case halves together. 

3.  Insert the six screws back into their positions and carefully tighten until snug. Do not cross the threads or over-tighten 

the screws. 

4.  Re-install batteries inside the battery compartment and close the battery door. Test all mechanical and electronic changes 

for proper operation.

Mode change is complete. Contact Hobby Services if questions as follows:

HOBBY SERVICES

3002 N. Apollo Drive, Suite 1

Champaign, IL 61822

Tel: (217) 3980-3630 (9:00am – 5:00pm CST, M-F)

E-mail: [email protected]

© 2014 Tactic, a Hobbico company

Reviews: