8
BATTERY ALARM
An alarm will sound and the display will show a warning when the Tx battery’s voltage drops to the level
shown in this setting. Do NOT set this value too low, as the radio could lose power very rapidly as the
battery nears full discharge and cause a loss of control of the model. Land the model immediately once
this alarm has sounded!
VIBRATION POWER
Adjust the intensity of the vibration from the internal vibration motor system.
BACK LIGHT
Adjust the intensity of the LCD’s red backlight.
Once all functions in this menu are set, press
ESC
to return to the home screen.
From the home screen, press and hold
ENTER
for 2 seconds to fi nd the MODEL SETUP menu for setting
of fundamental operating parameters as explained here.
MODEL SELECT
Memories are available to store parameters for up to 30 different models. With this selection highlighted
press
ENTER
. Press
or
to move the cursor up/down the screen to fi nd the desired memory to make
active, and press
ENTER
twice to confi rm the selection and automatically return to the home screen. Or
press
ESC
to return to the home screen.
Changing the model memory is not possible if the Tx battery voltage is too low. See the INPUT POWER
section on page 4. It’s a good idea to keep a record of all settings in each memory as a backup in case
parameters in a particular memory are accidentally changed, etc.
MODEL MANAGEMENT
Shows basic information regarding the model setup in the “Model” memory number at top-left. Move the
cursor up or down to select / change the function to adjust, and press
ENTER
to adjust the function.
Name:
With the cursor on this line press
ENTER
. The method for setting the model name is the
same as for entering the USER NAME as described on page 7. The maximum number of characters
is eleven. Press
ESC
when fi nished.
Model Type:
Press
to place the cursor on this line, and
ENTER
to highlight the selection. Press
or
to select the model type as airplane, helicopter, or quadcopter. Press
ENTER
to confi rm.
Model Copy:
To copy all parameters from one model memory to another, place the cursor at this
line and press
ENTER
. The “COPY FROM” page will show. Highlight the memory to copy FROM and
press
ENTER
. Now the “COPY TO” page will show.
Place the cursor over the memory number to copy TO, and press
ENTER
. The “COPY CONFIRM” screen
will show. To abandon the copy function as shown on-screen, highlight “NO” and press
ENTER
to return
to the “COPY TO” screen. Press
ESC
to return to the “MODEL MANAGEMENT” screen.
Otherwise, press
to highlight “YES” and press
ENTER
. All settings that previously existed in the receiving
memory will be permanently erased. The display will return to the COPY TO screen. Return to the “MODEL
SELECT” screen to confi rm the copy function was successful by looking at the memory that was copied “to”.
MODEL SETUP MENU – AIRPLANES
