2
MOUNTING ANYLINK
Mount AnyLink high on the rear of the Tx, and extend its antenna to
point upwards from the top of the Tx as much as possible. Rotate
the antenna as shown above. Two strips of hard locking fasteners
are included for attaching AnyLink to the rear of the host Tx.
INPUT POWER AND TRANSMITTER CONNECTIONS
Cables are included for attaching AnyLink to Futaba radios having
a square trainer jack, and compatible JR/Spektrum radios. Other
cables are available separately (see page 9). The cable with two
connectors is for Futaba. The cable with three connectors is for JR
and Spektrum. Using the appropriate cable, connect AnyLink to
the Tx as explained below.
Input Power Connection:
AnyLink
requires power to be taken from
the host Tx through the appropriate
cable. Insert the cable’s universal-
style servo plug into AnyLink’s INPUT
jack. Make sure the Tx battery is fully
charged prior to operation. Replace
weak alkaline batteries, or fully charge rechargeable batteries before
attempting a flight.
Futaba and Hitec Transmitters:
Connect the cable’s trainer plug
to the Tx trainer jack. This connection will provide both power and
signal from the Tx to AnyLink.
Input Jack
Cable
TACJ2000 AnyLink Mnl.indd 2
TACJ2000 AnyLink Mnl.indd 2
10/26/2011 1:04:27 PM
10/26/2011 1:04:27 PM
