11
TROUBLESHOOTING
RANGE IS SHORT:
Interference –
Check Rx installation and servo connections
.
Low Tx or Rx battery –
Replace the batteries or recharge as needed
.
Any Link case and/or antenna not oriented properly –
Rotate AnyLink on
Tx, or re-direct position of the antenna.
Rx location –
Relocate the Rx to a different position in the model for
better reception.
RUN TIME IS SHORT:
Low Tx battery –
Replace or recharge the batteries.
POWER IS APPLIED TO ADAPTER BUT SERVOS DO NOT FUNCTION:
Tx or Rx batteries are low –
Replace or recharge the batteries.
Rx switch off –
Turn on the ESC or switch harness.
Swi tch harness or ESC is connected incorrectly –
Check all connections
and the ESC instruction manual.
Rx not bound to AnyLink –
Perform binding process again.
INTERFERENCE OR SERVOS GLITCHING:
Out of range –
Operate the model more closely to the Tx.
AnyLink case not oriented properly –
Rotate AnyLink on Tx
.
Rx or ESC location –
Relocate the Rx and/or ESC away from the engine,
motor, servos, or linkages for better reception.
WRONG CONTROL SURFACES MOVE IN RESPECT TO TX INPUT:
Repeat all steps in AnyLink Operation section on page __.
CONTROL SURFACE MOVES IN THE WRONG DIRECTION:
Reverse the position of the Tx’s reversing switch for the appropriate channel.
ONLY ONE SERVO GLITCHES:
Servo is bad – Replace or repair the servo.
TACJ2000 AnyLink Mnl.indd 11
TACJ2000 AnyLink Mnl.indd 11
10/26/2011 1:04:29 PM
10/26/2011 1:04:29 PM
