Tactec TAC 310SX, Programming Instructions Manual

Page: 12 / 19

TAC 310 SX
CH#
TX(MHZ) RX(MHZ)
1
NNN.NNNN NNN.NNNN
2 NNN.NNNN
NNN.NNNN
3 NNN.NNNN
NNN.NNNN
4 NNN.NNNN NNN.NNNN
5 NNN.NNNN
NNN.NNNN
6
NNN.NNNN NNN.NNNN
7
NNN.NNNN NNN.NNNN
8 NNN.NNNN NNN.NNNN
9 NNN.NNNN NNN.NNNN
10 NNN.NNNN NNN.NNNN
11 NNN.NNNN NNN.NNNN
12 NNN.NNNN
NNN.NNNN
13 NNN.NNNN NNN.NNNN
14 NNN.NNNN NNN.NNNN
15 NNN.NNNN NNN.NNNN
16
NNN.NNNN NNN.NNNN
PRESS FUNCTION KEY:
1 TO EDIT
3 TO PROGRAM
5 WHEN FINISHED
6. Flip the SOCKET switch OFF and remove the EPROM.
EDITING
You may then proceed to edit the frequency list as follows.
1. Depress function key [fl]. Ttie display will add the following prompt at
the bottom of the screen:
EDIT CH #? ■
2. Enter the channel number you wish to edit, then press [RETURN].
3. The display then switches to the transmit edit menu as follows:
EDIT CHANNEL #N
TX FREQ (MHZ)
FROM: NNN.NNNN
TO: ? ■
4. Type in the new channel frequency (or "N/A"), then [RETURN]. You may leave
off any trailing zeroes (the computer will ignore them anyway). You must
enter
valid data (channel frequency or "N/A"). If you only press
[RETURN], the computer will "buzz" and wait for you to enter valid data.
If you decide to keep the same channel frequency, simply re-enter it on
the keyboard, then press [RETURN].
5. The screen will then switch to the receive edit menu. This menu looks the
same as the transmit edit menu, except that the second line reads RX FREQ
(MHZ) instead of TX FREQ (MHZ). Edit the receive frequency in the same
manner as in step 4.
6. The display will then add the following prompt at the bottom of the screen:
EDIT CH #? S
-
12
-