TACOFLOW3 MAX / MAX PRO
40
Instructions for installation and use
MKTG-TRA-MAN-E9135400-07/2019-ENG
12.3
STOP
1)
Remove the power supply to the circulator by moving the main switch (by the Customer) to
Pos. “0”
.
2)
Check the LED OFF on the circulator.
12.4
EMERGENCY STOP
In order to react to situations of danger that may occur suddenly, authorized operators must:
1)
Remove the power supply to the circulator by moving the main switch (by the Customer) to
Pos. “0”
.
2)
Check the LED OFF on the circulator.
DANGER
AFTER STOPPING THE CIRCULATOR AND SIGNALING THE EMERGENCY TO THE SUPERVISOR IT IS MANDATORY TO REFRAIN
FROM ANY INTERVENTION ON THE CIRCULATOR UP TO THE CONSENT OF THE SUPERVISOR.
DANGER
IT IS COMPULSORY TO VERIFY THAT THE CIRCULATOR IS IN
“SAFETY STATE”
BEFORE PERFORMING MAINTENANCE OR
ADJUSTMENTS. THERE ARE
RESIDUAL RISKS NO. 1, NO. 2
AND NO. 3 (SEE CHAP. 8)
.
12.4.1 RESET AFTER AN EMERGENCY STOP
After you remove the causes of the emergency and verify the absence of damage and/or anomalies to the line, acquire
the consent of the Supervisor to proceed as follows:
1)
Checks before starting
(see par. 12.1)
.
2)
Perform the start-up
(see par. 12.2)
.
