4 / GS-900 ANChOR & STERN LIGhT
1. Verify the Anchor & Stern Light does not interfere with other top-mounted
accessories.
2. Using the drill template provided, cut out a 2-1/2" diameter center hole on the top.
3. Position the base centered in the 2-1/2" hole.
4. Use the drill template to mark and then drill the three (3) bolt holes with a 1/4" bit.
5. Place a bead of marine-grade sealant on the underside edge of the backing plate.
This will prevent water intrusion.
6. With the assistance of a helper, position the backing plate around the base from
under the top, align the holes in the base with the backing plate and insert the bolts
through the base, top and backing plate.
7. hold the bolts securely with a screwdriver or socket wrench while the nuts are
threaded onto the bolts.
8. Tighten the nuts, being careful not to over-tighten and deform the top surface.
9. Clean any excess marine-grade sealant from the surface.
10. Operate unit to full up and down position and check for proper operation.
INSTALLATION
Always use high-quality, stainless-steel hardware when mounting
the base. Do not attempt to weld the base to any surface.
NOTE:
This product is intended for mounting on Fiberglass hardtops or Pilot
house enclosures. All of these styles of tops offer various mounting options.
The desired location in all cases is one that allows the mount to raise and
lower completely with no obstructions to other components on the top.
The best way to determine proper placement of the mount is
to (1) identify the location of all the other components on the
BASE
The light assembly is composed of two parts – one (1) Lamp
Assembly and one (1) Stanchion.
LIGHT
1. For the light to comply with USCG, it must be mounted at the highest point on the
boat, unobstructed by any other hardware.
2. Remove the light assembly by loosening the setscrews on the light head.
3. The stanchion provided is 32.75” long. The tube can be cut to required length.
4. Attach the 18-Gauge 3-wire harness (not provided) to the light assembly.
5. Feed wire down the tube and out through the grommet at the bottom of the
stanchion.
6. Connect switch to manufactures' recommendations.
