8 / GS-280 / 2801 OUTRIGGER MOUNT
• Remove the two hex head screws from the handle with an Allen wrench
• Remove the handle
• NOTE: you can get to the top screw easier if you pull down on the handle and
move it so it is in-between positions
• Pull off the plastic logo cap on the bottom of the unit
• Inside the unit there is a bolt head
• Use a ratchet, extension and a 9/16" socket
• Tighten the bolt clockwise about five turns
NOTE - Add a small amount of red Loctite to the threads of the bolt as well
• Once tightened,
• Reinstall the cap,
• Reinstall the rotation handle using the same screws that were removed
LOOSENING BASE
MAINTENANCE
If the 9/16" bolt on your GS-280 or GS-2801 loosens, please
follow these steps to tighten the base.
