Taco Marine GRAND SLAM 1000, Installation & Operation Instructions

Page: 7 / 14

GRAND SLAM 1000 / 7
The power button on the control panel for the GS-
1000 is a lock-down button. When pressed, the button
will light up and stay on until pressed again. Each time
the power button is pressed, the system will reset
the electronic system to the default setting. If the
system is shut off with outriggers in outward position,
outriggers will stay in position until proper buttons are
pushed to return outriggers to the default position.
Operation Manual for Outriggers Control Panel
POWER BUTTON (A)
The Port Mount/Starboard Mount (STBD) are lock-
down buttons (left/right) for which side outriggers
you are wanting to work with. Choose desired side
and press down button (will lock in). When button is
in center position, lift or rotate button will not work.
PORT MOUNT / STARBOARD MOUNT (STBD) (C)
When wanting to lift up/down outriggers, choose
the side (Port or STBD Mount) and lock down. And
then click the lift button (Up/Down) until you have
reached the desired level. With each click, the lights
will light (up or down) on the side you are working
on (Port/STBD Mount). When you reach the desired
level position, stop clicking the up/down button and
the outrigger will stay at that level until changed by
operator.
LIFT UP / DOWN BUTTON (E)
When wanting to rotate outrigger (Out/In), choose
the side (Port or STBD Mount) and then press and
hold down the unlock button (B) and press rotate
in/out button. By holding this button down, the
outrigger will move outward/inward, depending on
which arrow you are pushing. Arrows are switched
when using either Port Mount or Starboard Mount
(STBD). Follow the arrow directions when choosing
sides. For example, the left arrow will rotate the Port
outrigger away from boat with Port selected and will
bring STBD outrigger in when STBD is selected. When
reaching the desired location position, let off button
to stop motion. Outrigger will stay in this position until
changed by operator.
ROTATE (OUT/IN) BUTTON (D)
Keeping the Lower switch (E) depressed for more than five (5) seconds will return the outrigger
to the 0° position.
*NOTE:
In case of mechanical pump failure, there is a rocker switch mounted on the pump
assembly, and depressing this switch will manually lower the outriggers to where
they can be removed.