Technical data
Voltage rating: 3.7V
Battery type
：
3.7V Li-on / 0.6Ah
Charging voltage: 5V DC (USB)
Charging time: 2hr
No-speed: 5000/10000/15000 min
Collet size: ø2.3mm/ø3.2mm
Changing the parts
1.
2.
3.
4.
5.
Waring!
1.
2.
3.
4.
5.
6.
CHARGING THE TOOL
Connect the power supply (DC5V 500mA to 2000mA), Insert Micro USB into
the machine.
Turn the device off and ensure that the rotating part is stopped!
Push and hold the locking knob then turn the chuck until the button is fully
pushed in!
When the rotating part is clicked in, turn the locking knob down and pull
the parts/bit out from the tool.
Insert the new accessories into the chuck then fix the screw on while
pushing the locking knob
Finally, release the locking knob
Before using the tool, ensure that it is ready and safe to use!
Do not use in wet condition and enviroment!
Never use the tool near to flammable gas or liquids.
Do not force to operate the device when it slows down or stops turn it off
and finish the work process.
Wear glasses while using the tool.
Do not touch the drill/grinding tip during operation(even if it is in low speed),
because it can cause injury!
- 04 -
-1
