TACKLIFE PBS01A, Manual

Page: 26 / 28

• We recommend that you clean the device immediately each time you have finished using it
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep
into the device. The ingress of water into an electric tool i creases the risk of an electric shock.
Maintenance
There are no parts inside the equipment which require additional maintenance.
12. Storage
Store the device and its accessories in a dark, dry and frost-proof place that is inaccessible to
children. The optimum storage temperature is between 5 and 30
°
.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
13. Electrical Connection
The installed electric motor is connected and is ready to work.
The connection complies with the relevant VDE and DIN regulations.
The customer-side mains supply and the used extension line must meet these regulations.
Important information
In the event of an overloading the motor will switch itself off. After a cool-down period (time varies)
the motor can be switched back on again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical connection lines.
Causes are:
• Drag marks if connection lines are led through window or door clearances.
• Kinks due to improper attachment or routing of the connection line.
• Cuts caused by running over the connection line.
• Insulation damages caused by pulling the connection line out of the wall socket
• Fissures caused by the ageing of the insulation. Such defective electric connection lines must not
be used and are hazardous due to the insulation damages.
Regularly check the electrical connection lines for damages. Please make sure that the connection
lines are disconnected from the mains supply during the check.
Electrical connection lines must comply with the relevant VDE and DIN regulations. Only use
connection lines labelled with H05VV-F. The labelling of the connection cable with the type
specification is required.
AC motor