- EN -
Release the vertical angle lock (16) and set the sawing arm (5) to a vertical angle of 0° (in other
words the saw blade is at an angle of 90° to the mitre bench). Tighten the vertical angle lock
(16). (B7)
Hold an angle bracket against the bench (20) and the flat part of the saw blade. (B8)
NOTE:
The angle bracket must touch the flat part of the saw blade, not its teeth.
Turn the saw blade by hand and check the correct alignment between the saw blade and the
bench at several points.
The edge of the angle bracket should run parallel to the saw blade.
If the saw blade is not parallel to the angle bracket, make the adjustment as follows:
● Undo the lock nuts on the sawing head vertical angle (32) using a wrench or an adjustable
wrench. (B9)
● Undo the lock nut which is secured by the 0° vertical angle setting screw (33) using a wrench
or an adjustable wrench. Release the vertical angle lock (16). (B10)
● Adjust the screw on the sawing head vertical angle (32) with a screwdriver by turning it
clockwise and anti-clockwise so that the saw blade is on the 90° anglebracket.
● Undo the screw which holds the pointer on the vertical angle scale (17) and set the pointer
so that it points to zero. Tighten the screw again.
● Tighten the vertical angle lock (16) and the lock nut to secure the sawing head vertical angle
(32).
NOTE: The above procedure can also be used to check the angle of the saw blade relative to
the bench for a vertical angle of 45°. The 45° vertical angle setting screw (32) is on the other side
of the sawing arm.
SWITCHING ON THE LASER LINE
Switch on the ON/OFF switch for the laser light (2).
(B11)
ADJUSTING THE CUTTING DEPTH
Release the swing head lock (6) by pulling it. The sawing head will swing upwards. (B12)
Set the required cutting depth using the setting screw (29). (B13)
Secure the stop screw using the lock nut (31).
(B14)
SIDE SUPPORTS
Long pieces of wood can be supported using the side supports (35). (B16)
There are two positioning holes (36) on each side of the bench for the side supports.
The side supports must be completely locked in position before a workpiece is placed on them.
- 12 -
Summary of Contents for PMS03
