5
- LABEL SETTING PROCEDURE
1. Open (1)upper plate undoing (1)upper plate stopper.
2. Loosen thumb screw and slide outside roll guide(4) out of roll hanger(2).
3. Push label roll into roll hanger(2). Make sure label is on top.
4. Thread leading end of label between press rubber(6) and dispensing plate(8).
5. Continue to thread label as shown in picture. Grip leading end into the groove
in rewinder(10).
6. Adjust (6)press rubber with(6-1)press rubber adjust bolt for label tension.
7. Micro Switch is Label stop fuction. (7-2) gap roller have to be setted just on Label gap.
→ That time (7) approx sensor have to lamp. (7) approx sensor have not to lamp
when gap roller placed on labels.
You have to adjust (7-1) thickness adjust bolt to lamp on label gap and lamp off on label.
* Minimum label thickness is 50micron.(0.05mm)
8. Adjust (8)dispensing plate with (8-1)dispensing plate adjusting bolt for location
of label dispensing.
9. Turn power switch "on".
10. Close (1)upper plate and tighten (1-1)upper plate stopper
Note : press rubber(6) can be adjusted to achieved desired label tension
