www.tacautoparts.com Page 2 of 5 Rev. 10/21/22 (NL)
c.
Select (1) Driver/Left Front Bracket
(
#1
)
.
Attach the Bracket to the threaded end of the
Bolt Plate with (1) 8mm Flat Washer, (1) 8mm
Lock washer and (1) 8mm Hex Nut,
(Fig 4)
.
Do not tighten hardware at this time.
d.
Remove the 8mm Hex Bolt from the nut on the
Bolt Plate from
Step 2.1a
. Rotate the Bolt on
the Bolt Plate until the threaded nut lines up
with the remaining hole in the Mounting
Bracket and body panel,
(Fig 4)
. Attach the
Bracket to the threaded Nut Plate with (1)
8mm x 30mm Hex Bolt, (1) 8mm Lock Washer
and (1) 8mm Flat Washer,
(Fig 5)
. Do not
tighten hardware.
b.
Thread (1) 8mm Plastic Retainer onto the
threaded end and down tight against the body
panel,
(Fig 3)
.
NOTE
: The Plastic Retainer is
designed to keep the Bolt/Nut Plate from
falling into the body panel and to aid in
Bracket installation.
Models
with
factory threaded inserts:
a.
Attach (1) Driver/Left Front Bracket (
#1
) to the
threaded inserts with (2) 8mm x 30mm Hex
Bolts, (2) 8mm Lock Washers and (2) 8mm
Flat Washer,
(Figs 6 & 7)
. Do not tighten
hardware.
STEP 2.2
(Fig 3) Thread Plastic Retainer onto Bolt Plate to
hold Bole Plate in position.
Plastic Retainer
FIG 3
(Fig 4) Attach the bracket to the Bolt/Nut Plate.
Then Remove 8mm Hex Bolt. Rotate Bolt Plate to
line up with remaining factory hex shaped hole.
Front
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
Plastic Retainer
FIG 4
(Fig 5) Attach Bracket to threaded end of Bolt Plate
8mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Front
FIG 5
(Fig 6) Driver/left side front mid 2015-on (example
of models with factory installed threaded inserts)
Front
FIG 6
