www.tacautoparts.com Page 1 of 5 Rev. 10/21/22 (NL)
PLEASE NOTE THAT THE FOLLOWING
PICTURES ARE BASED ON THE DRIVER
SIDE INSTALLATION
8mm Plastic
Retainer
x6
8mm Flat
Washer
x18
8mm Lock
Washer
x12
x24
x6
8mm Bolt/Nut
Plate
8mm x 30mm
Hex Bolt
x6
x6
x12
x12
x36
8mm Hex
Nut
8mm Nylon
Lock Nut
6mm Nylon
Lock Nut
6mm Flat
Washer
6mm x 25mm
Hex Bolt
6mm Lock
Washer
6mm Hex
Nut
x12
x12
6mm x 20mm
T-Bolt
x12
(Fig 1) 2009-mid 2015 driver front mounting
location (No factory holes in pinch weld on 2009-
2012 models). The two small hex holes are
mounting holes, the large slot hole is required to
assist installation.
Front
Remove Cover
FIG 1
(Fig 2) Insert 8mm Bolt/Nut Plate(NOTE
：
8mm Bolt-
Nut Plate is not required on models with threaded
inserts).
IMPORTANT: Do not let go of the hex bolt
until after Plastic Retainer has been threaded onto
bolt (Fig 3)
FIG 2
STEP 2.1
Determine the correct procedure to attach the
driver side front Bracket for your model/year:
Models
without
factory threaded inserts in
body panel:
a.
Select (1) 8mm Bolt/nut Plate. Partially thread
an 8mm Hex Bolt onto the threaded of the
Nut Plate. Thread the Hex Bolt in until it is
flush with the welded nut. Use the Hex Bolt
as a handle and insert the Bolt and Nut Plate
into the oval hole,
(Fig 2)
. Feed the threaded
bolt on the Bolt Plate through one of the hex
shaped factory holes.
STEP 1
Starting at the driver side-front of the vehicle,
remove the sealing tape covering the factory
holes in the side of the inner panel,
(Fig 1)
.
