TabTimer™ helps keep medications on time™ |
www.TabTimer.com.au
| 1300 TAB TIMER
(1300 822 846)
Pricing and specifications are correct at the time of publishing and may change without notice. Your health professional should be consulted prior to using any TabTimer
product to establish the suitability of a TabTimer product for use, administration or storage of any medications. In purchasing and continuing to use our products you have
agreed to and accept the Terms and Conditions shown on our website. Images are for illustration purposes only. Errors and omissions excluded.
TabTimer™, 'helps keep medications on time™' and the TabTimer™ logo are registered trademarks of TabTimer Pty Ltd © TabTimer Pty Ltd ABN: 99 137 415 948
To Set The Alarm Times
1.
Press button ‘1’ and release
2.
‘Alarm 1’ symbol should be shown, flashing on the left hand side
4.
Press button ‘2’ to change the hours, Press button ‘3’ to change the minutes
5.
Press ‘1’ to lock in the time setting and advance to the next alarm
6.
‘Alarm 2’ symbol will flash, continue as above the change the hours & minutes
7.
If required, continue as above to set alarms 3 - 4 – 5 & 6 and press 1 to return to the time display
8.
Only program the alarm times you need , leave the remaining unused alarms on ‘--:--‘
9.
If you need to cancel an alarm change the hours to ‘--:--‘
this setting will appear if you change the hours to the one after 23:00 or after the midnight setting
Loading Medicines
Load the pills in an anti clockwise direction, do not leave any spaces
The device comes with 6 templates/ dosing rings, for 1 to 6 doses per day
Use the correct template to aid loading
All of the templates assume medicines will be filled to start from a Monday
If you start on a different day, or are doing 5 or 6 dosage alarms per day,
you may need to modify, disregard, or create your own template
Ensure The tray is aligned and rotating correctly
After filling, lifting, or moving the tray, to ensure cogs are aligned correctly,
always go into test mode and rotate the device mechanically
Each time you open the device, move the tray, lift the tray, or fill it, you might not have the tray sitting
on the cog correctly. It is wise to position the tray a few spaces back, then go into the test mode and
use the motor to rotate the tray to the correct position.
Use the built in test function to rotate the tray
o
Ensure the LCD display is visible
(If left for long period of inactivity Tip to activate, or press 3)
o
Lift the tray and position a few spaces back
o
Press button ‘2’ for approximately 6 seconds, until Test Mode ‘CH’ is displayed
o
Press button ‘1’ to run through the test
o
The device will show all display (CH1), rotate (CH2), alarm and flash (CH3)
o
Tip the device to stop the alarm and wait for it to return to CH
o
Repeat the test by pressing button ‘1’
o
Stop the tests when the next due dose is immediately to the right of the opening in the lid
o
When finished exit the test mode by pressing button ‘3’
To Change The Alarm Sound/Tone
1.
Hold down button ‘3’ and at the same time hold button ‘1’
2.
The device will rotate around 3 different alarm tones and also a silent setting
3.
Symbols indicate the chosen tone ;
A
- Tone 1
B
- Tone 2
C
- Tone 3
Blank
- No audible alarm, just flashing light
4.
Release the buttons when the desired tone is heard
To stop the alarm
During normal operation. When the alarms sound, simply tip the medicine out of the hole,
this will stop the alarm.
Direct Light
Ensure the device is not under a direct light or sunlight.
This can affect the sensor that detects how many spaces the device rotate.
