7
Assembly and Disassembly of the foil.
— 04
— 02
By steps :
Assembly
Disassembly
1
Mount the wings on the fuselage: the front
wing with 3 M8x30mm Torx screws for the UP
1250, 3 M8x30mm Torx screws for the UP 1600
and 2 M8x30/1 M8x35mm Torx screws for the
UP 2000; the rear stabilizer by 2 M6x12mm Torx
screws.
2
Fix the fuselage to the mast with the 2 M8x30
mm Torx screws.
3
Mount the mast on the board using the board
mount by following the instructions on the next
section (see Section 5).
1
First remove the rear stabilizer and then the
front wing.
2
Remove the fuselage from the mast.
3
Remove the mast from the board.
WARNING
Be sure to tighten all the components until you obtain an optimal, one-piece assembly without forcing or dama-
ging the foil.
It is recommended to apply a torque of 10 N.m.
1
2
3
1
All TAAROA foils have a specific mast mounting and dismounting system on the foil’s fuselage. This
system is called the Standard Windfoil Mount (SWM) for the UP series, and it is the same as on the
Windfoil range. This allows the components of TAAROA foils to be easily interchanged for more mo-
dularity between the UP and Windfoil range.
— 01
Mast mounting systems
Standard Windfoil Mount
EN