Page 6
The Build
7. Once it reached at the end of Pre-cut slot, use a scissor or wire
cutter to cut down the excess stripe.
8. Use the Medium or HV Cyno to glue the stripe.
9. Wipe out the excess glue if needed using the tissue paper.
10. Use the spray activator to cure it and fast forward the process.
11. Repeat the same process for other stripe as well as shown in the
picture above.
12. Use the same 3 X 0.5mm stripe to reinforce the ailerons as well.
Glue one of the two carbon stripes that goes in cross shape in the
ailerons as shown above.
8
9
11
12
7
10
10
CUT
GEL GLUE (HV)
ACTIVATOR
3X0.5MM STRIPE
