The Build
85. Use the assembly jig to center the elevator.
86. With the jig in place, Cut the rod at the position shown in the above
image to fit in the quick link.
Make sure you have the servo centered.
87. Above is the finished linkage setup with elevator centered and rod
well fitted and glued in both the quick links with all the guides in place.
88. Before moving to the upper half of the fuselage, make sure you
have glued the rudder servo in the designated slot with the servo arm
centered.
89. Use the same process as gluing the bottom of the fuselage to glue
the top of the fuselage into place.
90. Engage all the tab and slots. Press firmly along the length of
the fuselage to make sure all areas are fully seated. Check that the top
piece is square and straight. Tweak if necessary to make it true.
85
87
86
88
89
90
Page 19
CUT
GEL GLUE (HV)
