T3 Innovation
3
Safety Information
To ensure safe operation of the Power Prowler™, follow the instructions
carefully and observe the warning and caution messages listed below.
Failure to observe warnings can result in severe injury or death and can
damage the unit.
Notification
Definition
The Power Prowler™ is designed for use on cabling systems with
or without voltage.
• The Voltage! Icon turns on when the voltage exceeds Safety
Extra Low Voltage (SELV) rating of 60 volts peak AC or DC
max.
• Internal components are protected to 600 volts RMS peak AC
or DC max.
• Operating the Power Prowler when a voltage source exceeds
600 volts RMS peak AC or DC max may damage the unit and
pose a safety hazard for the user.
Do not place equipment and its accessories in the trash. Items must
be properly disposed in accordance with local regulations.
• Do not use the Power Prowler or cables if they appear
damaged or the unit is not working properly.
• Verify the Power Prowler’s operation by testing a
known voltage.
• Do not use with voltages higher than the Power Prowler’s
rated voltage (600V).
• When connecting to energized cabling use appropriate
accessories that meet or exceed the cables voltages.
• Use with caution with voltages greater than 30V AC RMS, 42V
AC peak, or 60V DC.
• Disconnect circuit power and discharge high-voltage
capacitors when testing capacitance, continuity, diodes, or
resistance.
• Do not use around explosive or flammable gas.
• Use only test leads approved by a safety agency and that have
the same voltage, amperage, and category as the
Power Prowler.
• Before opening the battery door, remove any connected
adapters and cables.
• Always wear personal protective equipment when working
with the Power Prowler.
It is recommended to use caution when handling the probes and
cable connections on the Power Prowler™ when the Voltage!
Icon is present.
