T Scale IHB++ -300, Techical Manual

Page: 17 / 20

IHB++ Series Technical Manual
- 15 -
8. CALIBRATION

Turn on the scale.

Press key during self checking, display will be show
f 1 unt

Press key until display will be show
tech

Note: Before enter the tech menu, press calibration switch, which is
locating below the scale

Press and keys, display will be show
p 1 lin
8.1 Linear Calibration
li near

Press key to enter calibration, display will be shown
pi n

Press and keys, display will be show kg or lb, press key
to select the calibration unit kilograms or pounds, press key ,display will be
show
Load0
.

*Note: Ensure the pan is empty

After stable and zero indicator on, display will be show
Load1

Place the first calibration mass weight on the pan.

After stable and zero indicator on, display will be show
Load 2

Add again the second calibration mass weight on the pan.

After stable and zero indicator on, display will be show
Load 3

Add again the third calibration mass weight on the pan.

After stable and zero indicator on, display will be show
Load 4

Add again the fourth calibration mass weight on the pan, ( *Note: Calibration
mass weight should be full capacity of the scale )

After stable and zero indicator on, display will be show
load 0
Remove the
calibration mass weight from the pan

*Note: Ensure the pan is empty

After stable and zero indicator on, display will be show
Load 4

Place the calibration mass weight on the pan, ( *Note: Calibration mass
weight should be full capacity of the scale )

After stable and zero indicator on, display will be show
Load 3

Remove the fourth calibration mass weight from the pan