T.MIX DPM-1122, Owner'S Manual

Page: 9 / 20

9
17. PEAK LED
Inside your DPM 1122 the audio signal is monitored in several different stages and then sent to the PEAK
LED. When the LED is red illuminated, it warns you that you are reaching signal saturation and possible
distortion. Then you should reduce the input level for avoiding distortion.
18. FADER
This fader will adjust the overall level of this channel and set the amount of signal sent to the main mix.
19. +48 Volt Phantom Power & LED
It is available only to the XLR MIC sockets. This LED illuminates when
power is switched on. Never plug in a microphone when phantom power
is already on. Before turning phantom power on, make sure that all faders
are down. In this way you will protect your stage monitors and main
loudspeakers.
20. LAMP
This lovable LAMP is very convenient for your operation, it is located in the
top right corner of the front panel, and provides the 12V socket that can drive
standard XLR-type (pin1 is for ground, pin 2 is for live terminal, pin3 is not
connected) lamps.
Note:
don’t connect a microphone to this jack, otherwise, the microphone would
be damaged.
21. AUX IN
This 3.5 mm Ø stereo jack joins the same mix bus with the Tape IN input. It can
be connected to MP3- or CD players, computers, etc.
22. 2-TRACK IN/OUT
- TAPE IN: Use the Tape input if you wish to listen to your mix from a Tape
or DAT Recorder.
- TAPE OUT: These RCA jacks will route the main mix into a tape recorder.
23. AUX RETURNS
Use these stereo 1/4’’ sockets to return the sound of an effect unit to the main
mix. You can also use them as the extra auxiliary inputs, but they are primarily
used to connect the output of external processors.
DSP SECTION
There is a powerful 24-bit/100 presets digital multi-effects included in your DPM
1122. Effects include reverbs, chorus, flanger, delay, and combinations of the above.
24. PRESET Selector & DISPLAY
Adjust this knob to select the right effect you wish to perform and the display
interface indicates selected preset. There are totally 100 options for you: Echo,
Vocal, Plate, and versatile two-effect combinations. When you are satisfied with the
right preset, please push this knob to store this preset you want.
25. PEAK/MUTE Switch & LED
This switch is used to activate/deactivate the effect facility. Sometimes, you can also
use the FX FOOTSWITCH (
4%
) for convenient operation. The LED lights up when the
signal sent to effect is too strong, in case of the digital effect module being muted,
this LED also lights up.
26. FX1 TO AUX1/FX2 TO AUX2 Level Control
This knob is used to adjust the level of the processed signal which is sent from the
DSP to AUX1/2 bus.