T.MIX DPM-1122, Owner'S Manual

Page: 10 / 20

10
27. FX1/2 TO MAIN Level Control
This fader is used to adjust the level of the processed signal which is sent from the
DSP to MAIN MIX bus.
28. AUX1-4 Controls
These knobs are used to adjust the amount of the signal sent from the AUX
SENDS1-4 jacks to the AUX1, 2 ,3 and 4 buses.
29. 2-TRACK IN LEVEL Control
This knob is used to adjust the level of the signal sent from the 2TR
IN and AUX IN jacks to the MAIN MIX bus. The adjustable range
goes from -
∞ to +10dB.
30. AFL Switch & LED
When this switch is ON, the LED will light up and the output signal
that passes through the corresponding fader or knob is sent to the
AFL/PFL mix bus.
31. PHONES/CTRL-ROOM Control
This knob is used to adjust the level of PHONES output, which can
be varied from -∞ to +10dB.
32. AFL/PFL/MAIN Switch & LED
By pressing the switch, you can choose the output signal source of PHONES/CTRL-ROOM. When the
switch is OFF, the stereo LED meter will indicate the signal level of MAIN MIX OUT outputs, when the
switch is ON, the AFL/PFL LED lights up. Then the LED meter indicates the signal level of AFL/PFL mix
bus.
33. LED METER Display
The LED meter display indicates the output signal level.
34. STEREO GRAPHIC EQ
Each one of these faders will boost or attenuate the selected frequency at
a preset bandwidth. When all faders are in centre position, the output of the
equalizer is in flat response.
35. EQ Switch & LED
Engage this button to add the stereo graphic EQ into the main mix output
circuit, also the LED lights up. It can be used to modify the frequency
“contour” of a sound. If you release the button free, the stereo graphic EQ
will be bypassed.
36. POWER LED
This LED will light up when the unit is powered on.
37. THRESHOLD Control & LED
The threshold control has a range of -40 to +22dB, allowing applications
from low level compression to high level limiting. The threshold control
determines the audio level above which level reduction occurs. When the
signal peaks exceed the selected threshold, the LED lights up and level
reduction occurs.
38. RATIO Control
This control determines the ratio of change in output level to change in input
level for signal above threshold. If the output remains constant no matter
how high the input level, we have an infinite input/output ratio. It should
be remembered that the control has no effect on signal portions below
threshold.