Quick Install Guide
STEP - LCD5500 Programming
Local programming of basic options can be done through a standard DSC Power LCD keypad.
Connect the keypad on the T-Link TL300 Keybus terminals. Access to programming mode uses
the same code as the console (default is '5555'). All other sections will have to be programmed
via the TLINK console software
•
A 2-minute timing delay begins when entering the programming mode. At the end of the
timing delay T-Link will exit program mode and save the changes made regardless of
where the programmer is in the programming sequence
•
After powering up the T-Link TL300 wait until the Stat light starts flashing.
•
Access the Installer mode using [*][8], followed by the installer code. (5555 at default)
NOTE: The [*] and [#] keys are not supported to re-enter installer code in the event of an
incorrect entry. All keys will be ignored if the correct sequence following [*][8] is not
entered.
•
Four Programming Sections are available and will be displayed in the sequence indicated
below.
[001] T-Link IP Address:
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
[003] T-Link Account Code
|___|___|___|___|___|___|___|___|___|___|
[007] Primary Receiver IP Address
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
[007] Primary Receiver Gateway IP Address
|___|___|___|.|___|___|___|.|___|___|___|.|___|___|___|
When programming is completed, press the [#] key to save changes and exit programming mode.
