FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 15 of 18
11/12/2013
67.
Position the headlight trim as shown, then
loosely secure it in place, using 10g x 3/4"
screws (5), 3/16" x Ø3/4" flat washers (5) &
10g speed nuts (5) so that the fasteners will
still allow adjustment.
Place the speed clips on top of the
headlight trim tabs (not clipped on) so
that the clips are not visible when on the
FPS.
To position the headlight trim, the holes
in the trim must match those in the FPS.
Where required, slot the headlight trim
holes for adjustment.
68.
Repeat the previous step for the opposite
side of the FPS.
Steps 69 through to 71 only apply if headlight
washers were originally installed. Otherwise,
proceed to step 72.
69.
Unplug the OE washer tube &, using the
supplied cable tie, connect it to the supplied
3/8”
→ 1/4
” reducer fitting.
70.
Cut a length off the 3/16” rubber hose &,
using the supplied cable ties, fit one end to
the 3/8”
→ 1/4
” reducer fitting & the other
to the inlet of the 3/16” Y connector.
71.
Using the remaining 3/16” rubber hose &
supplied cable ties, connect each outlet of
the 3/16” Y connector to a 3/16” one way
check valve.
Steps 72 through to 74 only apply if parking
sensors are to be installed. Otherwise,
proceed to step 75.
72.
Remove the O.E. parking sensors & wiring
assembly from the O.E. bumper.
73.
Using the O.E. parking sensor shrouds,
install the parking sensors to the FPS.
74.
Run the O.E. parking sensor wiring through
the indicated openings & connect all of the
O.E. parking sensors.
WASHER NOZZLE
WASHER NOZZLE
3/16” ONE WAY CHECK
VALVE
3/16” ONE WAY CHECK
VALVE
Y CONNECTOR
3/8” → 1/4” REDUCER FITTING
OE WASHER TUBE
RHS SHOWN
