FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Toyota LandCruiser 200 Series 2007+
Part No.
070SB13R82A
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia
wide.
File: F-1434.docx
Page 14 of 18
11/12/2013
58.
Repeat the previous two steps for the
opposite side of the FPS.
59.
Adjust the fog-lights so that they are
positioned in the center of the pressing &
are projecting forward.
60.
As per the table below, route & splice the
indicator/park light’s wiring to the vehicle,
then solder & seal the joins.
LED WIRING
Ground
Parker
Indicator
White
Brown
Yellow
61.
Check the operation of the indicator/park
lights, then un-plug them.
62.
Insert the nylon plugs supplied, into the
square cut-outs for the indicator/park lights
(as shown).
63.
Separate the indicator/park light body from
the backing plate.
64.
Secure the backing plate to the FPS, using
the screws provided with the light
assemblies.
65.
Supporting the backing plate, re-fit (clip)
each indicator / park light body (ensuring
that an adequate seal is achieved).
Ensure that the park light is towards
the outside of the vehicle
.
66.
Repeat the previous six steps for the
opposite side of the FPS.