3
5.2.
Installation of the pressure line
This pump is equipped with a garden hose adapter as standard.
Connect the garden hose to the pump's adapter with a quick
coupling (Fig. 1) to drain the waste water from the pool. This
allows the pump to be mounted and disassembled quickly and
easily.
Fig. 1
To avoid flow losses, it is advisable to use a pressure line with a diameter equal to that of the pump pressure
connection as a minimum.
Use a flexible hose suitable for this purpose, e.g. a commercially available garden hose or similar, as a pressure
line.
5.3.
StatiPositioning the pump
Place the pump in the deepest part of the water on your pool cover. The pump must be installed in a horizontal
position. Point the open end of the pool's garden hose away from the pool. Connect the pump to the electrical
circuit (Fig.2).
In addition, when positioning the pump, make sure that the maximum immersion depth specified in the technical
data is not exceeded. During subsequent operation, the water level will then be reduced to the minimum suction
level (Fig. 3).
Fig. 2
Fig. 3
6. Electrical connection
The unit is equipped with a mains connection cable and a mains plug. It must only be replaced by qualified staff to
avoid any danger. Please do not use the mains connection cable to carry the pump, and do not use this cable to
pull off the plug from the socket, either. Protect the mains connection cable and mains plug from heat, oil or sharp
edges.
The values stated in the technical details have to correspond to the mains voltage. The person
responsible for the installation has to make sure that the electrical connection is earthed in
compliance with the applicable standards.
The electrical connection has to be equipped with a highly sensitive residual current circuit-
breaker (FI switch): ∆ = 30 mA (DIN VDE 0100-739).
If extension cables are used, their cross-section must not be smaller than that of rubber-
sheathed cables of the H05RN-F (3 x 0.75 mm²) short code. The mains socket and the plug-
and-socket elements have to be in splash water-proof design.
7. Putting into operation
Please make sure that the electrical plug connections are in the flood-proof area.
As long as the device is connected to the electrical mains, one must never re
ach with one’s
hands into the opening of the pump.
9
