Page 3 of 6
C-95003 MEGA BENCH - ASSEMBLY INSTRUCTION
THIS UNIT REQUIRES (1) 9/16 WRENCH AND (1) 11/16 WRENCH FOR ASSEMBLY. DO NOT
TIGHTEN HARDWARE UNTIL INSTRUCTED TO DO SO. DO NOT OVER TIGHTEN.
01) TURN FRONT SEAT AND REAR SEAT UPSIDE DOWN ON LEVEL SURFACE. ATTACH HINGE
TO FRONT AND REAR SEAT WITH (6) 3/8 X 2 BOLT AND (6) 3/8 FLAT WASHER FINGER TIGHT.
02) SLIDE HINGE TUBE OVER TOP RAIL OF BODY. PUSH (2) 2 PLASTIC FEET ONTO FOOT PUSH
(4) 2 PLASTIC FEET ONTO HEAD. INSERT FOOT INTO BODY AND INSTAL (1) L PIN ATTACH
HEAD TO BODY WITH (3) 3/8 X 3 BOLTS, (6) 3/8 FLAT WASHER AND (3) 3/8 LOCKNUT. SET
UNIT ON LEVEL SURFACE AND TIGHTEN HARDWARE CENTER SEAT ON BODY AND TIGHTEN
HARDWARE. DO NOT OVER TIGHTEN.
03) PUSH (4) SLEEVES INTO HEAD AND (1) SLEEVE INTO BODY. INSTAL (2) GRIPS ON (2)
INSERTS. PUSH (2) INSERTS INTO HEAD. SET HEIGHT WITH (2) L PIN AND (2) HAND KNOBS.
04) SET CROSS BAR ONTO CATCHES ON HEAD SET SEAT ON CROSS BAR AND LOCK
LOCATION WITH (1) L PIN AND (1) HAND KNOB.
05) INSTAL (8) PLUGS ON HINGE, (2) HAND KNOBS ON HEAD, (1) L PIN AND HAND KNOB
ON BODY.
HARDWARE LIST
(06) 3/8” X 2” BOLT
(03) 3/8” X 3” BOLT
(12) 3/8” FLAT WASHER
(03) 3/8” LOCK NUT
(04) 2” X 1 3/4” SLEEVES
2” FOOT
(06)
L PIN
(05)
(06) HAND KNOB
HAND GRIP
(02)
(07) 1” SQ. PLUG
(02)
HAND GRIP
NOTE: ALL SIZES ARE IN INCHES & SOME PARTS ARE PRE ASSEMBLED.
