t.amp E-1500, User Manual

Page: 15 / 40

Depending on the individual application, the amplifier can be used in different operation
modes:
Stereo mode
The two amplifier channels operate independently of one another, either
channel (A and B) is amplified and connected to loudspeakers, the volume can
be controlled separately for the two outputs.
Parallel mode
The two amplifier channels receive the same input signal from channel A and
loudspeakers are connected to each amplifier, the volume is controlled via the
control knob for channel A.
Bridged mode
The two amplifier channels are internally connected in such a way that twice
the output power is available. Only the input signal from channel A is amplified
and loudspeakers are connected only to the correspondingly marked output.
The volume is controlled via the control knob for channel A.
For each output of the amplifier, the total impedance resulting from the loudspeakers con‐
nected to it must not be below the allowed minimal impedance of the amplifier output. If you
connect more than one loudspeaker to an amplifier output, please note the following:
n
If the loudspeakers are connected in a series, the individual impedances will be added up.
Possible operation modes
Installation and starting up
E-400, E-800, E-1200, E-1500
15
Power Amplifier