27
Amplifier
CWT SE
loudspeakers can be connected to any amplifier designed for a 4 Ohm
speaker load. However, if you wish to exploit the full sound potential of these
speakers, we recommend power amplifiers which are capable stable of
supplying high currents. (>5 Ampere for CWT SE 500,>10 Ampere for CWT SE
1000 und CWT SE 2000)
Loudspeaker binding posts and loudspeaker cables can carry dangerously high
voltages. Be sure to switch off the amplifier before carrying out any wiring work.
Cable
The cables employed in any Hi-Fi system have a crucial influence on the sound
of the system as a whole. For this reason
has developed its own range of
cables which includes the ideal type for every application. These cables are
designed to match the special characteristics of our loudspeakers. Please note
that all the cables used should be the same length!
Standard - connections
In the standard wiring arrangement only one speaker cable is required for each
loudspeaker. The linking bridges between
Bass
and
Mid / High
must be left in
place.
In bi-wiring and bi-amping arrangements the cables bridging of the woofer
(Bass) and mid/high (Mid/High) input terminals must be removed!
Bi - Wiring
Bi-wiring provides better sound by separating the bass (
Bass
) signal and mid-
range/treble signals (
Mid/High
). Two speaker cables are required for each
loudspeaker.
If your power amplifier has two loudspeaker outputs (
A
and
B
), the
speakers are connected as shown in the illustration below; If the power amplifier
has outputs for only one pair of loudspeakers, connect both cables to these
outputs in parallel.