T+A MP 200, User Manual

Page: 34 / 60

Source selection
rocker
Source selection
buttons
Source operation
Selecting a source
• Select the desired source by pressing the corresponding source
selection button on the device repeatedly, if necessary, or press the
source selection button on the remote control repeatedly until the
source is shown in the display.
• When operating the MP 200 without a DAC 200 or HA 200, the source
can alternatively be selected via the ... buttons on the remote
control ( press) repeatedly if necessary.
j
If the MP 200 is operated in a system network with a DAC 200 or an HA 200, the source selection buttons
... of the remote control are used for the source selection of the DAC 200 or HA 200 sources. In this case,
source selection at the MP 200 via remote control is done exclusively via source selection rocker.
For a faster and more convenient source selection, not required sources can be deactivated in the system
settings. See chapter
System settings .
As soon as you have selected the desired source on the MP 200, a connected DAC 200 or HA 200 automatically
selects its system input for playback. The display of the DAC 200 or HA 200 now shows SYS IN.
If the MP 200 is already set to the correct source, but another source has been selected for playback on the
DAC 200 or HA 200 in the meantime, it is possible to switch to the system input of the DAC 200 or HA 200 by
briefly pressing the source selection button of the MP 200 once again.
34