T+A M 10, User Manual

Page: 39 / 54

39

 

(Loudspeaker terminals)
The M10 is equipped with four high-quality
WBT 0710-nextgen- loudspeaker terminals, rendering it
suitable for bi-amping and bi-wiring modes. It features
two separate out-put stages which can either be wired in
parallel or used for bi-amping.
Notes on possible bi-wiring / bi-amping arrangements for
the
M10 can be found in the Technical Summary, in the
chapter entitled ‘Back panel controls’, and in the wiring
diagrams in the Appendix.
The output stages are designed to cope with a minimum
load of 2
Ω but continuous operation at very high volume
produces high currents in the power output stages which
can lead to overheating. This in turn trips the protective
circuit which switches the amplifier off automatically.
It is important to ensure that the terminal clamps are
firmly screwed down, and that no short-circuits can occur
through wire "whiskers" at the terminals.
A selection of excellent cable is available as accessories
matching to the

units. Please ask your

specialist dealer.
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be
connected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool such
as a pliers.