15
Installation:
1.
Battery:
Please use lithium chargeable 3.7V flat battery 18650.
Remove battery compartment cap and make sure setting the po-
sitive polar towards to the direction inward.
Attention
: Battery
discharge protection: remove the adhesive film from the battery
terminal before inserting!Put the cap back and screw it until tight.
(Fail to do so may result in restarting!).
2.
Adjustments:
To check the function after the installation of bat-
tery. First, rotate and adjust the eyepiece dioptre adjustment ring
until you see the four-character icon on the screen ( there's no
need to see a clear image ), then rotate the Objective lens adjust-
ment ring until you can see your target clearly. Second, switch to
different modes, test IR, Red dot or Rangefinder.
3.
Adapter installation:
Outfit the adapter to front side of the de -
vice, screw it to the bottom to fix the adapter tight. Using screws
to fix the device onto scope. (Or use tape to assist the installa-
tion).
1. Turn On/Off
Turn on the device with a short press of Power button. Turn off the
device with a long press of Power button. Power indicator will keep
ON when the device is turned on.
2. Sleep Mode
Enter sleep mode with a short press of Power/Sleep button when
the device is turned on. Power indicator will keep ON when the de-
vice entering sleep mode.
3. The Eyepiece Dioptre Adjustment
The purpose of dioptre adjustment is to get a clear image for users
with different vision. Rotate and adjust the dioptre adjustment ring
until you get a clear view of the four-character icon on the screen.
One adjustment only for each eye-view.
4. The Objective Lens Adjustment
Make sure the eyepiece dioptre adjustment is finished. Aiming at
your target, rotate and adjust the objective lens ring until you get a
clear and well-focused image.