Welcome
Congratulations on the purchase of your new kettle SY-HV27. In order to fully benefit from this product
please read the following instructions carefully. Store this user manual in a safe place for future
references.
Safety instructions
o
This appliance is designed for domestic use only and not for commercial applications
Sytech is not responsible for damage resulting from improper use or from non-
compliance with the user manual.
o
This appliance is designed for boiling water only. Never operate the kettle with any
liquids other than water.
o
Before inserting the mains plug into the socket, ensure that the power voltage and
rating comply with the rated electric parameter shown on the appliance label.
o
Do not operate the appliance with wet hands.
o
Never allow the base or the bottom of the kettle to make contact with water. Never
immerse the base or the kettle in water. Should any of the above occur, contact
Sytech Service Centre before using it again.
o
In order to comply with safety regulations and to avoid hazards, repairs of electrical
appliances must be carried out by qualified personnel. If repairs are needed, please
contact Sytech Service Centre.
o
If the supply cord is damaged, contact Sytech Service Centre.
o
DO NOT operate the appliance if:
The appliance or the power cord are damaged
The appliance has been dropped.
o
Always remove the plug from the wall socket:
After use
In case of any malfunction
Before cleaning
o
When removing the plug from the wall socket, never pull on the power cord.
o
Always place the appliance away from children.
o
Children must be supervised to ensure that they do not play with the appliance.
o
Do not attempt to remove any parts of the housing nor insert any metal objects into
the interior of the appliance.
o
To prevent damage to the power cord, always keep it away from sharp edges or
corners.
o
Do not place the power cord over or near hot surfaces.
o
Do not expose the appliance to rain or moisture and do not operate the appliance
outdoors or with wet hands.
o
Only use clean cold water, and let the water run for approximately 1-2 minutes before
filling.
