REAL TIME SETTING
1. Set the Function Selector (14)
to”OFF”. Connect the mains lead to the power supply. The
clock display will flash on and off indicating a power interruption and that the displayed time is
incorrect.
2. To set the correct time, press the Time Set Button (2) and Hour Set Button (7), or Minute Set
Button (8), together, until the correct time is displayed.
3. Open the Battery Door (16) on the back of the unit and put in a 6LR61 (or equivalent) 9-volt
battery (battery not included). The purpose of this battery is to store the information relating to
alarm time and to keep the clock functioning in the event of disconnection from the mains
supply or power interruption. Should this occur, the clock would continue to keep time, but will
not display.
PLEASE NOTE: When operating from battery only, the clock will only remain accurate for a short
period of time. It is important that the mains supply is restored as soon as possible.
ALARM TIME SETTING
1. Press the Alarm Set Button (1) and simultaneously press the Hour Set Button (7) or Minute
Set Button (8) as appropriate until the required alarm time is reached.
2. To double check the alarm time, simply press the Alarm Set Button (1) then the display will
show the pre-set alarm time.
RADIO OPERATION
For AM reception, this unit uses an internal directional aerial, rotate the unit for best reception.
For FM reception, the wire FM Antenna (5) on the back of the unit should be fully unwound.
1. Set the Function Selector (14) to the
“ON” position.
2. Set the Band Selector (10) to the required waveband.
3. Use the Tuning Control (11) to select the desired station.
4. Adjust the Volume Control (9) to the desired listening level.
5. To turn off the radio, set the Function Selector (14) to
”OFF”. If the radio does not switch off
this may be caused by inadvertent operation of the Sleep Set Button (3). To cancel this, press
the Snooze Button (6) once.
WAKE TO RADIO
Having selected your desired station and adjusted the desired listening level, proceed as follows:
1. Follow
the instructions for “ALARM TIME SETTING” above.
2. When the desired alarm time has been selected, set the Function Selector (14) to the
“AUTO”
position.
3. The radio will switch on automatically at the pre-set alarm time.
4. The alarm can be temporarily stopped for 9 minutes by pressing the Snooze Button (6) once.
5. Depress the Alarm Set Button (1) to turn off the radio. The alarm will activate again after 24
hours unless the Function Selector (14
) is set to “OFF”.
