5
Do not unscrew the boiler cap unless you are sure that the appliance has been unplugged from
the outlet (fig. 2).
When water in boiler is lack,” Lack water” pilot lamp (16) lights up, unscrew the safety cap (7).
Pour 1.0 litres (12) of normal tap water into the tank (figure 2) by means of a funnel. Screw the
safety cap back on tightly (7).
How to start the appliance
-Check that the voltage indicated on the data plate corresponds with that of the local network
before connecting the appliance to the supply mains.
-The appliance uses ordinary tap water. If the water is very hard we suggest using distilled or
demineralized water.
-Always remove the plug from the power socket before filling the boiler
Unscrew the cap (7) and pour in about 1.0 litres of water.
-After closing the cap. Connect the appliance to the power supply.
-Press the boiler’s switch (4) and wait for the water to start boiling (about 8 minutes). Next, press
the switch (5) to turn on the iron and then select the desired temperature by means of the
thermostat knob (9).
-When the light (11) goes off, the set temperature has been reached and the iron is ready for use.
It takes about 8 minutes for the boiler to reach the optimum ironing pressure.
-When the appliance is ready for use the steam pilot lamp (6) lights up.
-When using the iron for the first time, iron a plain cloth first.
-To obtain steam, press the steam button (10). Release the steam button when steam is no
longer required.
-This appliance is also able to generate steam in a vertical position and can therefore be used
to refresh fabrics easily with a jet of steam.
-If the jet of steam decreases while you are ironing, the boiler tank is running out of water.
Attention: never allow the steam to flow out of the iron whilst it is resting on the stand
provided (8).
Attention: the boiler is always under pressure!
How to fill the boiler while the appliance is being used
To continue ironing, top up as follows:
-Switch off the boiler (4). Select the desired temperature “MIN” by turning the thermostat knobs
(9).
-Release the pressure left in the boiler, keeping the steam button (10)
on the iron
pressed down
until no more steam comes out of the plate. Then switch off the
iron
(5).
-Unplug the power cord from the wall socket.
-Wait for the iron and the boiler to cool down.
-Unscrew the cap and wait a few minutes.
-Slowly pour 1.0 litres of water into the opening always using the funnel provided.
-Close the boiler and fully tighten the cap.
-Press the boiler switch (4).
-Wait for steam pilot lamp (6) to light up before continuing ironing.
Summary of Contents for Easy Life SY-EP22
Page 1: ......
