28
4111-0004 — Apr. 2021
© 2021 Systems, LLC
Optional Equipment
Quick Cycle Lip Extend (Lip Out)
Note:
For dock levelers equipped with optional Quick
Cycle Lip Extend/Lip Out, the dock leveler lip can be
extended independently of the leveler platform with
the following sequence:
1. Complete steps 1-4 in “Operating Instructions” on
page 26.
2. When leveler has risen enough for lip to clear the
transport vehicle bed, press and hold the LIP button
in addition to the RAISE button. Leveler will stop
raising and lip will extend.
3. When lip has fully extended, release RAISE and
LIP buttons. Leveler will fall into transport vehicle with
lip fully extended.
4. Continue with step 5 in “Operating Instructions.”
Emergency Stop (E-Stop)
Note:
For dock levelers equipped with optional
Emergency Stop (E-Stop), dock leveler can be halted
in place by using the Emergency Stop button:
1. While operating any function of the dock leveler,
press the EMERGENCY STOP button.
2. Equipment being operated will halt in place.
3. When hazard has been cleared or system must
be operated, pull the EMERGENCY STOP button
outward.
4. Continue operating dock equipment as needed.
Auto Return To Dock (ARTD)
Note:
For dock levelers equipped with optional Auto
Return To Dock (ARTD), the dock leveler can self-
store if a transport vehicle departs the loading dock
before the platform is stored.
To enable Auto Return To Dock, turn the ARTD switch
to the ON position. If end loading or unloading is
required, turn the ARTD switch to the OFF position
and follow the steps on page 27. When end loading or
unloading is complete, turn the ARTD switch back to
the ON position, and the dock leveler will self-store.
Whenever end loading or unloading with the
platform in the below-dock position, make sure
the ARTD switch is in the OFF position. DO NOT
turn the ARTD switch to the ON position until end
loading or unloading is finished.
When Emergency Stop is active, DO NOT go under
the dock leveler, walk or drive on the dock leveler,
or leave forklift and/or material sitting on the leveler!
If Emergency Stop button is pressed with the dock
leveler unsupported in the working zone, the leveler
will descend when E-Stop is released!
Always make sure the platform is properly
supported in the raised position before entering the
pit or going under the dock leveler.
OPERATION
