sWiFi/all
User Manual
12
7. Settings
Apply power to sWiFi/all and press the RST(Reset) switch for less than 3 seconds to operate in setup mode.
RDY(Yellow) LED flashes every 0.4 seconds at this time. Then run the sWiFiConfig utility and launch the
sWiFi>Connect menu on the top menu bar as below.
There are two methods to setup sWiFi/all. One is “Serial” method that connects to the RS232 serial
communication port(COM port) on the PC, and the other is “Network” method that connects the sWiFi/all with
PC WiFi and access to the IP of sWiFi/all for settings.
1) “Serial” method
The “Serial” method, which is the setup by connecting to the RS232 serial communication port(COM port) on
the PC, connects with sWiFi/all with the corresponding serial port on utility.
Login with ID/PW: sWiFi/99999999. Please note that sWiFi is lowercase.
*If setup is required while using sWiFi/all as RS422 and RS485 ports, there is a method to use RS232 port on
the PC and to set them as “Network” access in the description below.
