Portbase User Guide
Chapter 4
Installation
This chapter explains how you can make Portbase to communicate. It deals with LAN and serial
connection guides for Portbase to operate together with the target serial device.
1.
Installing Portbase
Follow the steps below to install Portbase. In most cases, Portbase’s factory default settings should be
sufficient for most serial connections; however, some of the configuration settings may have to be
changed for your particular installation. Portbase can be wall mounted, set on the desktop, or mounted
using the optional DIN rail kit.
1. Before attempting to install Portbase, make sure you have installed and set up your serial equipment as
described in the documentation that came with the device.
2. Write down the 12-digit MAC (Media Access Code) address printed on the label located on the bottom
of Portbase. You may need this number in order to configure Portbase.
3. Connect Portbase to your equipment using an RJ-45 serial connector.
4. Plug Portbase power supply adapter into a suitable AC receptacle, and then plug the power supply
cable into Portbase. Portbase will run through a sequence of power-up diagnostics for a few seconds.
If Portbase is operating properly, the RDY LED will blink constantly in a regular
pattern. PWR LED should also be on.
If the RDY LED does not blink continuously in a regular pattern, a problem exists. If
this is the case, try powering the unit OFF and then ON again. If the problem persists,
refer to the Troubleshooting section in this User Guide.
5. Connect Portbase to your network through a switch or hub using a category 5 (CAT5) Ethernet cable.
Portbase’s IP address must be configured before a network connection is available. If your network
offers DHCP (Dynamic Host Configuration Protocol), Portbase will automatically search for a DHCP
server upon power up and obtain an IP address. If your network does not offer DHCP, a static
(fixed) IP address must be assigned (see your system administrator for assistance). In most cases, a
fixed IP address is preferred because a DHCP server may not always assign the same IP address to
Portbase when Portbase is powered ON.
16
ECHIPAMENTE PENTRU AUTOMATIZĂRI
Electric Film S.R.L. — Aleea Scarisoara 3, Apt.42 ▪ Cluj Napoca, Cluj ▪ 400445 ▪ www.electricfilm.eu
VÂNZĂRI ▪ 0364 710319 ▪ [email protected] ▪ SUPORT TEHNIC ▪ 0788 250583
cele mai sensibile
16/45
