Eddy-CPU User Guide
48
5.
GPIO Commands
Configure operation mode and value for each Programmable I/O pins.
z
set gpio <0~15> mode [in / out]
(Default: Output)
Set current pin’s I/O mode.
z
set gpio <0~15> value [low / high]
(Default: High)
Set current pin’s output value. (This option only applies to output mode pins)
6.
Username/Password Commands
Configure username and password for Web/Telnet.
z
set user <username>
(Default: eddy)
Set username. 16 Characters at maximum.
z
set pass <password>
(Default: 99999999)
Set password. 16 Characters at maximum.
7.
System Commands
z
set default
Restore all settings to factory default. Requires reboot for changes to take effect.
z
set save
Save current configuration settings. Requires reboot for changes to take effect.
z
reboot
Reboot Eddy.
Summary of Contents for Eddy-CPU
