2
TPI 16-05
The adjusting and arresting mechanism shown in Figure 2
is used only with the dampers
IMOS - RK
and it is used
with the dampers
IMOS - RKT
if b
≤
900, and allows
adjustment of the damper channel blades. To the pin 3,
which is attached to the channel blade is by a welded con-
nection 8, 9, 1 an adjustment lever 5 connected. The
screw 7 and wing nut 6 are parts of set position of channel
blades. Direction of opening and closing of the damper is
indicated by stickers on the side channel 2, where also a
damper holder is.
Fig.2 Adjusting and arresting mechanism for
IMOS-RK axb-R and IMOS-RKT axb- R if b
≤≤
900
Adjusting mechanism shown in fig.3 is used only for
IMOS-
RKT
dampers, which have the nominal dimension b>900.
It is delivered in two models and is mounted next to the side
channel 1. Fig.3a shows the manufacture of a mechanism
that supplements adjusting and arresting mechanism
shown in fig.2. Two pins 4 and 2 go through the side chan-
nel 1. After mounting of adjustment and arresting mecha-
nism are a lever 3 and two levers 10 put on the pin 2 and
two pins 4. The lever 3 is fixed by welded connection 7, 8,
9 and levers 10 by safety ring 11. Levers 10 and 3 are con-
nected by the connecting rod 5, its pins are secured by
safety ring 6.
Fig 3 Adjusting and arresting mechanism for
a - IMOS-RKT axb-R if b
>>
900
b - IMOS-RKT axb-S if b
>>
900
