D450-03-00
4
I56-374-05R
© System Sensor 2001
Three-Year Limited Warranty
System Sensor warrants its enclosed smoke detector base to be free from
defects in materials and workmanship under normal use and service for a
period of three years from date of manufacture. System Sensor makes no
other express warranty for this smoke detector base. No agent, representa-
tive, dealer, or employee of the Company has the authority to increase or
alter the obligations or limitations of this Warranty. The Company’s obli-
gation of this Warranty shall be limited to the repair or replacement of any
part of the smoke detector base which is found to be defective in materi-
als or workmanship under normal use and service during the three year
period commencing with the date of manufacture. After phoning System
Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return
Authorization number, send defective units postage prepaid to: System
Sensor, Repair Department, RA #__________, 3825 Ohio Avenue, St.
Charles, IL 60174. Please include a note describing the malfunction and
suspected cause of failure. The Company shall not be obligated to repair or
replace units which are found to be defective because of damage, unrea-
sonable use, modifications, or alterations occurring after the date of man-
ufacture. In no case shall the Company be liable for any consequential or
incidental damages for breach of this or any other Warranty, expressed or
implied whatsoever, even if the loss or damage is caused by the Company’s
negligence or fault. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This Warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
Tamperproof Feature
Do not use the tamperproof feature if the XR5 removal tool
is to be used.
This detector base can be made tamperproof to prevent the
removal of the detector head without the use of a tool. To
activate this feature, break off the tab on the detector base
as shown in Figure 3A, then install the detector. To remove
the detector from the base once the tamperproof feature
has been activated, place a small-bladed screwdriver into
CAUTION
PLASTIC LEVER
BREAK TAB AT
DOTTED LINE BY
TWISTING TOWARD
CENTER OF BASE.
USE SMALL-BLADED
SCREWDRIVER TO
PUSH PLASTIC LEVER
IN DIRECTION OF
ARROW.
the small hole on the side of the base and push the plastic
lever away from the detector head (see Figure 3B). This
will allow the detector to be rotated counterclockwise for
removal.
NOTE:
Head removal after the tamperproof feature has
been activated first requires removal of the decora-
tive ring.
The tamperproof feature may be defeated by breaking and
removing the plastic lever from the base; however, this pre-
vents ever using the feature again.
Figure 3A. Activating tamperproof feature:
Figure 3B. Removing detector head from base:
A78-1175-03A
A78-1175-03B
Please refer to insert for the Limitations of Fire Alarm Systems
