25
systembuild.com
STEP17
Tube
You
* raw surfaces are shaded
7
(x49)
#A21110
U
B
D
Q
V
1st
2nd
Align the upper back panel with the top of the unit.
Align the side edges with the edge of the left upper end
panel (A) and right upper end panel (B) and nail straight into the
back edges as shown.
IMPORTANT!
DO NOT HAMMER IN THE NAILS IN THE CENTER
ROW UNTIL UPPER BACK PANEL IS IN PLACE AS THE BACK
PANELS WILL OVERLAP.
Align the lower back panel with the bottom edge of part (Q). Align the side edges with the
edge of the lower left and lower right panels (C) & (D) and nail straight into the back edges as shown.
Following this step the unit should be stood upright.
IMPORTANT!
THE BACK PANELS ARE A STRUCTURAL PART OF THIS UNIT AND MUST
BE INSTALLED PROPERLY.
2 people are required for this step. Carefully turn the unit over onto
its front side as shown. Assure that the unit is square. Distance from
corner to corner must be equal as shown.
7
Summary of Contents for 9979340COM
