In static mode, you must configure all the parameters manually - to do so you will probably
need the assistance of your IT support.
If you plugged the MR directly to your computer, only the
IP address
is relevant. If you
plugged it to a network, you must fill all the parameters if you want the MR to be able to
reach Internet.
The most important setting is the
IP address
that you want to give to the MR. It should be a
private address within one of the following ranges:
192.168.0.0 to 192.168.255.255
172.16.0.0 to 172.31.255.255
10.0.0.0 to 10.255.255.255
The
Netmask
is 255.255.255.0 by default, and should remain like this except if you know
exactly what you're doing.
The
Gateway
address must be filled if you connect the MR on a network. This is the IP
address of the router.
Same thing for the
Nameserver
. The default is 8.8.8.8 and should work fine.
NOTE:
After you changed the IP address of the MR and clicked Apply, you're not connected
to the MR anymore. You need to enter this new IP address in the address bar of your
Web browser in order to reconnect to the WebUI. Check the LCD of the MR to know
the IP address of the MR.
4.3.4
Wi-Fi
You can enable the Wi-Fi service and the Wi-Fi hardware by checking the
Enabled
checkbox.
When enabled, the MR behaves as a Wi-Fi access point. This means it broadcasts a network name
(
SSID
), and you can connect to it with your Laptop or Smartphone. The MR uses a static IP
address (
192.168.30.1
), and will give a dynamic IP address to your Laptop/Smartphone when the
connection is established – it acts as a DHCP server.
You can configure the
SSID
(Service Set Identifier, it's the network name broadcasted by the MR).
If none is provided, the default SSID is “MR3000-12345678” (where 12345678 is the serial number
of the MR).
You can also configure the
Channel
, between 1 and 11. You can check which channels are used
by the different access points nearby, and choose the less used to have better performance.
We recommend enabling
Encryption
. Do not use an open connection, as anybody could connect
to the MR3000 and tamper with the instrument. The WPA2 is the latest version of the encryption
protocol and the recommended choice. Use the WPA mode only if your computer doesn't support
the WPA2.
Encryption (WPA2 or WPA) requires a
Password
. The default password is
swissmade
. We
recommend to change this password.
MR3000CMR3000C_TR_v2.0_rev1.odt
subject to technical change without notice
39
