Copyright 2020 by Synthetic Sound Labs LLC - 3650 Digital Sequencer
Page | 9
Pressing a NOTE key that is
below
the root key, the CV OUT will be transposed
down
by however many steps the
key you pressed is below the root key.
To transpose farther than what is currently displayed on the keyboard, you can use the OCTAVE UP and OCTAVE
DOWN buttons to shift the keyboard octave. Select the octave you want, then press the key for the amount you
want to transpose. You can also instantly jump to a transpose key in another octave (one up or one down) by
holding one of the OCTAVE buttons and pressing the desired key.
There are a few other buttons that work in LIVE TRANSPOSE mode that might come in handy during a live
performance:
•
REST: Makes the next step a REST (one time only)
•
LOOP: Loops back to the beginning of the song or sequence on the next step (one time only)
•
ACC:
Turns on ACC OUT on the next step (one time only)
Important Notes:
You cannot transpose past the range of the CV output. For example, if you have a note in your sequence that is
the lowest C, then you try to transpose down from there, the output isn’t going to get any lower.
For maximum
transposeability, we recommend programming your sequences in the middle octaves.
Also, if you use the RUN button to pause the sequencer then start it again, whatever transpose amount you set
will be retained. If you press RESET to go back to the beginning of the sequence, then the transpose amount will
be cleared.
LIVE EDIT
Normally when a sequence is running, the NOTE buttons do not do anything. With LIVE EDIT mode enabled, you
can use the NOTE buttons to program your sequence on the fly.
Purpose
Entering notes into a running sequence.
Default
Disabled / Off
Operation
To enable or disable LIVE EDIT mode, hold PROG/RESET down and tap the ACC/[EDIT] button. The ACC LED will
blink twice for enabled and flicker for disabled.
When the sequencer is running, pressing a NOTE button will program that note into the current step. You can
also program a REST or a LOOP during live editing.
Important Notes:
The changes you make using LIVE EDIT are not
written to the sequencer’s non
-volatile memory until you
pause/stop the sequencer. Do no
t disconnect power while it’s running
,
or you’ll lose your changes!
(This does
not apply to using the normal PROGRAM mode; those changes are saved immediately.)
RUN / RESET MODE
This is another mode you can enable for START IN. When enabled, the sequencer starts when START IN goes
high and resets when it goes low.
