13
14
EN
EN
EN
EN
High
Level
Medium
Low
3
treating with
treating with
Step 2.
Clean your skin and dry it with a towel.
Step 3.
Turn on the
system. Select the Low
level
setting. The device will not work if you do not select an
setting. If you feel comfortable, raise the energy level to the
Medium or High setting.
Step 4.
If you use the designated shaver/ epilator, press the
accessory activation button on the control panel once
to run the epilator mechanism at low speed. If desired,
press it again to run the epilator at high speed. The shaver
cartridge operates only at Speed level 1.
Step 5.
Remove the applicator from the base.
Step 6.
Press the
activation button located on the
applicator. You will hear the fan inside the applicator.
Step 7.
Gently place the applicator on your skin, so that the
two RF silver contact bars are in complete contact with the
skin. The
will emit pulses.
Note:
The applicator will not work unless both RF silver contact bars are
touching the skin
Note:
The applicator will automatically turn itself off if it is not in use for 30
seconds. To turn the applicator back on, press the
activation button
located on the applicator
Step 8.
After every flash, glide the applicator slowly to the next neighboring spot
over the skin by moving it in one continuous, slow motion.
Avoid overlap between adjacent pulses.
DO NOT
hold the applicator window still over one spot on the skin and flash
multiple light pulses on the same spot on the skin. Doing so may cause too
much heat to build up and may result in skin swelling, blisters, or temporary
or permanent changes in the color of your skin. After each flash, move the
applicator to a different skin spot.
Wait for at least 10 seconds before returning to a previously treated skin spot.
6
7
Step 9.
For effective results, me should be used at least according to the treatment
times indicated below.
The minimum treatment times recommended below may vary from person to
person. We recommend to see that each treatment area is covered by 2-3 pulses:
Tips:
When using the system on difficult-to-treat areas
(e.g. underarm) apply the applicator in 2 directions:
left/right and up/down for full coverage.
You can treat all body areas during the same treatment session.
2 minutes
per shoulder
5 minutes
per abdomen
6 minutes
per chest
12 minutes
per back
1 minute
per underarm
2 minutes
per bikini area
3 minutes
per arm
10 minutes
per full leg
2 minutes
