Symphonic CSHP80G, Service Manual

Page: 17 / 65

1-7-1 E41A1INT
HOW TO SELF-CHECK AND INITIALIZE THE DVR with DVD Player
1. Turn on the DVR with DVD Player recorder.
2. To put the DVR with DVD Player recorder into the HDD mode, press [DVR] on the remote control unit.
3. To put the DVR with DVD Player recorder into the self-check mode, after pressing [ANGLE] button, press the
[3], [6], and [9] buttons on the remote control in that order within three seconds.
Fig. a appears on the screen and all LEDs light.
Fig. a: Self-Check Mode Screen
4. Upon the self-check completion, Fig. b appears on the screen.
Fig. b: Screen of Finishing Self-Check Mode
Table 1: Description of Fig. a
INDICATION DESCRIPTION
HDD CONNECT STATUS (*1) Connecting Condition of HDD
HDD POWER ON HOURS (*2)
Value of HDD power on hours obtained from S.M.A.R.T. command. (If not obtainable,
value of HDD power on hours is “0”.)
Value in parentheses is the factory setting value. (If no setting, the value is “0”.)
BE Ver. (*3) B/E version
Sub Micon Ver. (*4) Sub micro controller version
Table 2: Indication of HDD self-check (*5)
INDICATION DESCRIPTION
OK Connection of HDD is normal.
NOT FOUND HDD drive cannot be found.
CABLE ERROR FFC cable between the ATA CBA and the HDD drive is not connected correctly.
Self-Analysys and Report
HDD CONNECT STATUS :
HDD POWER ON HOURS :
BE Ver. :
Sub Micon Ver. :
G6*******Q1U
NFQ2B**D1
*1
*2
*3
*4
"*******" differs depending on the models.
Self-Analysys and Report
HDD CONNECT STATUS : OK
HDD POWER ON HOURS : 100(40)
*5
*6
*7
BE Ver. :
Sub Micon Ver. :
FACTORY DEFAULT :
POWER OFF :
ENTER
POWER
G6*******Q1U
NFQ2B**D1
"*******" differs depending on the models.