3
H
I
2) Install mounting nuts (J) onto 1/2”
IPS inlet connections on faucet
body (H). Using a wrench, finish
with one-half turn.
DO NOT
over-
tighten.
1
1
11
H
J
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON to
relieve water pressure.
1) Insert faucet body (H) through
mounting gasket (I) and sink
holes.
3) Seat flange (K2) into sink (K3 gas-
ket optional). Install gasket (K4),
washer (K5) and nut (K6) onto
flange (K2) from below sink, but
do not secure nut. Screw on tail
piece (K7) and hand tighten.
2
3
K2
K7
PLUMBER
PUTTY
OPTIONAL
K3
K4
K5
K6
4) Turn tail piece (K7) and flange
(K2) so pivot is facing toward
faucet. Pull assembly down into
drain hole. Secure hardware from
below sink. Install stopper (K1) in
the removable or non-removable
position.
2
3
K7
PIVOT
K2
K1
5) Attach inner washer (K8), pivot rod
(K9) and outer washer (K10) to tail-
piece (K7). Hand tighten nut (K11)
to secure pivot rod (K9).
K9
K7
1
K8
K10
K11
2
6) Connect lift rod (B) to clevis strap
(K13) and secure with thumb
screw (K14). Insert pivot rod
(K9) through spring clip (K12)
and clevis strap (K13). Secure
with spring clip (K12) and adjust
linkage if necessary.
3
4
4
K12
K9
K13
2
K14
K13
1
B
Installation